Your Cart

Electronics Parts

Model: ISC 3039
Winding - 100% Copper; Step Down - Converts 220V AC to 18V AC; Type - 18-0-18; AC to AC ConverterInput - 220V AC; Weight - 360 Grams; Size: 60x25x50mm (LBH); Mounting Hole - 3.5 x 7.5mm; Centre Distance - 69.5mmOutput - 18V AC; Ampere - 1A; Step Down Centre Tapped TransformerUsed for variety of appl..
Model: ISC 1839-4
Product Specification:Resistance Value: 3.3K OhmsRated Power: 0.25 Watt (1/4W); Tolerance : +/- 5%Carbon Film Resistors - Through Hole; Flame Retardant CoatingStiff 24 gauge leads (0.022 inches, 0.55 mm) perfect for solderless plug-in breadboardsPackage Include 250 x 3.3K Ohm Resistor..
Model: ISC 1819
Product Specification:The CD4068BE is a CMOS 8-input NAND/AND Gate provides the system designer with direct implementation of the positive-logic 8-input NAND and AND functions and supplements the existing family of CMOS gates.Medium speed operation - tPHL, tPLH=75ns (typical) at VDD=10V. Buffered in..
Model: ISC 710
Product Specifications:For Original Product Select "Sold and fulfilled by INVENTO SALES"Temperature range :-50-110 ℃; Temperature control mode: ON / OFF; Resolution:When temperature is 0.1℃, the resolution is -9.9~99.9, other temperature segment is 1℃; Control accuracy: 0.1 ℃Dimensions: 48.5 * 40mm;..
Model: ISC 1620
Product Specifications:0.28" inch LED digital display with Red & Blue LED dual display DC Volt Amp MeterOperating voltage:DC 4.5 ~ 30V. Measure voltage: DC 0 ~ 100V;Minimum resolution (V): 0.1VOperating Current: <20mA;Minimum resolution (A): 0.01A;Measure current: 1-10AOperating Humidity: 10 ..
Model: ISC 1421
Product Specifications:Level control interface for 5V or 3.3VPositioning holes: 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install, to achieve inter-module combinationControl Interface: A total of four pins (GND, VCC, DIO, CLK), GND to ground, VCC is the..
Model: ISC 961
Product Specifications:Package Include 1 x 0.96'' OLEDInterface: I2C interface.Screen Size: 0.96 inch, Resolution: 128 X 64.Working current: 25mA (Max).Dimensions: 1.38 in x 1.34 in x 0.47 in (3.5*3.4*1.2cm)...
Model: ISC 1647
Product Specification:LED Back light: Blue/Yellow Green (Depend on Stock Availability)Display capacity: 8 × 2 characters; Controller: SPLC78DModule Outline Size: 58 x 32 x 10 mm; View Area: 37.8 x 16 mmWorking temperature: -20~+70°C; Storage temperature: -30~+80°CPackage Include 1 x LCD..
Model: ISC 848
Product Specifications:VCC: Power interface ,5VIN: Control interface .Drive Current at least 4mAWith power and relay action indication, bright when connect and go off when disconnects.It can be not only used as a microcontroller development board module, but also as a home appliance control.It can n..
Model: ISC 296
Product Specifications:FOR: ESC LIPO Battery MotorProvides a secure connection for battery and motor connectionsEliminates the possibility of wrong polarity connectionsQuantity: 1 x male and female pairSize: 3.3cm / 1.29 " * 1.5cm / 0.59"..
Model: ISC 589
Product Specifications:High-performance, Low-power AVR 8-bit MicrocontrollerAdvanced RISC Architecture – 130 Powerful Instructions – Most Single-clock Cycle Execution – 32 x 8 General Purpose Working Registers – Fully Static Operation – Up to 16 MIPS Throughput at 16 MHz – On-chip 2-cycle Multiplier..
Model: ISC 754
Product Specifications:It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motorsThe emitters of the lower transistors of each bridge are connected together and the corresponding ..
Showing 1 to 12 of 639 (54 Pages)
This is the sticky Notification module. You can use it for any message such as cookie notices, special promotions, or any other important text.
Track Order