-200x200w.jpg "Stepper Motor")
Model: ISC 144
Product Specifications:Select "Sold and fulfilled by Invento Sales" for Genuine ProductThe comparator output signal clean waveform is good, driving ability, than 15mAUsing the sensitive type photosensitive resistance sensorWorking voltage: 3.3V-5VOutput: DO digital switch output (0 and 1), AO analog..
₹130.00
Model: ISC 169
Product Specifications:Model: RS-775WC-8514RPM : 19500 rpmCurrent : 2.7A - 19A (Max)Operating Voltage : 6V - 20VNominal Voltage: 18VOutput : 8W - 300 Watts (approx)Weight - 383 GramsTorque: 1.5 Kg-cm (153 mN-m) - (at max speed)Motor Outer Diameter: 46mmMotor Length: 66mmMotor Shaft Diameter: 5mmMoto..
₹660.00
Model: ISC 815
Product Specifications:Can be used for 3-5V DC power supply modules . When the power is turned on, the red powerUsing the comparator LM393, stableThe output port OUT sensor module can be directly connected to the microcontroller IO port , you can directly drive a 5V relay ; Connection : VCC-VCC; GND..
₹120.00
Model: ISC 962
Product Specifications:For Original Product Select SOLD AND FULFILLED BY INVENTO SALESMain chip: ISD1820Working voltage: DC 3 ~ 5V10 seconds recording,easy to use.the module can directly drive the 8 ohm 0.5W small speakers..
₹260.00
Model: ISC 229
Product Specifications:PS2 Joystick Joysticks standard interface Module Electronic Building Blocks and 2.54mm Pin interface leads.Phillips is a Two-Way Rocker 10K resistor, with the Joystick in a Different Direction, Tap the Resistance Vary"This Module Uses a 5V supply, the original state X, Y Reado..
₹150.00
Model: ISC 1071
Product Specification:Working Voltage: 3.5-5.5VWorking Current: <25mABrand new and high qualityPackage Include 1 x Active Buzzer..
₹140.00
Model: ISC 081
Product Specifications:For Original Product Select "Sold and fulfilled by Invento Sales"Gyro: ENC-03RC x3Firmware: Quadcopter V2.5 KrChip: Atmega168Length: 49mm..
₹1,299.00
Model: ISC 914
Product Specifications:The knock sensor, detects the knocks and the taps. It can work like a switch. The sensor output normally stays at High logic. The spring inside this sensor vibrates when knock or tap is detected and sends pulse or multiple high low pulses.Working voltage: DC 3~5VDefault Output..
₹199.00
Model: ISC 1074
Product Specification:Using 5050 full color LEDThrough the PWM adjusting three primary colors can be mixed to obtain different colorsWith a variety of single-chip interfaceLED drive mode: common cathode driverPackage Include 1 x RGB SMD LED Module..
₹140.00
Model: ISC 1070
Product Specification:Simple circuit of digital temperature module and integrated LED connecting to digital 13 interface to make temperature indicator light. Use number 13 interface to connect the integrated LED, connect digital temperature sensor to number 3 interface. When the digital temperature ..
₹140.00
Model: ISC 362
Product Specifications:High working power to 46v,large current can reach 3A MAX and continue current is 2A, power to 25WCan drive one 2–phase stepper motor, one 4–phase stepper motor or two DC motors.Built–in 78M05,get power from drive power,however, when drive power over12V, please use the external..
₹260.00
Model: ISC 707
Product Specifications:Operating voltage 5VPower 5MwWavelength 650n mThis 5V laser head very easy to use, you can use UNO control, do controllable laser pointer, theft detection, etc. interesting application devices. Whenever the laser can not point to themselves or others eyes, even if the case is ..
₹140.00